|
|
| PCB Design | ||
| Author 398338 Views 8 Posted at 2008/9/2 14:37 [View In Forum] | ||
|
Hi guys, sorry for all the stupid questions I've been asking lately. :roll: :wink: baxf baxf baxf baxf I am after a bit of a pointer in the right direction if possible...baxf baxf baxf baxf I currently have the Eagle and PCB Wizard 3.50 software packages.baxf baxf baxf baxf Basicly, I am designing a little PCB to mount and interface two modules together (One being GPS, one being GSM).baxf baxf baxf baxf Both of the modules have Board to Board connection, baxf baxf baxf baxf GSM - B2B Male connector, 1.27mm pitch, 2x30 (60pin).baxf baxf GPS - B2B Male, 2mm pitch, 2x10 (20pin).baxf baxf baxf baxf Essentially all my circuit needs to do is supply power to the modules, and have their respective PCB headers joined via tracks where appropriate (for RS232 data).baxf baxf baxf baxf It really is simple, but I cant seem to get started! For a start, in neither package can i find the correct PCB headers (female board to board type), if I had those, It'd be a lot easier to actually start joining bits together!baxf baxf baxf baxf If anyone can offer assistance I'd appreciate it!baxf baxf baxf baxf Many thanks |
| Reply No. | Replier | Total Replies 2 [View All Replies] [New Reply] | Replied at |
| 1 | chdd | Update, I just found the GSM connector library for Eagle.......so I have that one done! (No idea about how to make it into a circuit though) :s |
2008/9/2 14:37 |
| 2 | hualeyan | This issue worthy of discussion | 2010/6/18 04:24 |
Total Replies 2 Thread Per Page 10
|
|||
